Vermont Castings 360DVSR Operations Instructions download pdf (Page 10)

Vermont Castings, Majestic Products, 360DVS Series

10002547

Alternative Switch Location

The remote switch can be installed on the front or the

side of the access door. Simply mount the switch to the

bracket provided and screw the bracket to either side

of the frame, lining up the screws with the prepunched

holes (Fig. 8).

Remote_Switch

Gas

Control

Valve

Remote ON/OFF switch

Fig. 7 Remote switch wiring diagram for R models

The fireplace, when installed, must be

electrically connected and grounded in

accordance with local codes; in the

absence of local codes, use the current

CSA C22.1 Canadian Electrical Code.

For USA installations, follow the local

codes and National Electrical Code

ANSI/ NFPA No. 70.

It is strongly suggested the wiring of the

EB-1 Electrical Junction Box be carried

out by a licensed electrician.

Ensure power to the supply line has

been disconnected before commencing

with this procedure.

The EB-1 electrical junction box has been supplied

standard on this model to allow for easy connection of

the optional fan kits (Fig. 6).

To connect the EB-1 box to the house electrical supply

follow the steps below.

1. Remove the front cover of the EB-1 box.

2. Remove the plug socket assembly from the EB-1

box.

3. Feed the supply line in from the out through the

electrical knockout.

4. Connect the ground wire of the supply line to the

green screw of the socket assembly.

5. Connect the white wire of the power line to the

chrome screw of the socket assembly.

6. Connect the black wire of the power supply line to

the brass screw (polarized) of the socket assembly.

7. Refit the socket assembly back into the electrical

box and replace the cover plate.

8. The EB-1 electrical junction box is now ready to

supply power to the FK12 or FK24 fan kit, if used.

EB-1 Electrical Junction Box

Connection

Remote ON/OFF Switch Installation

EB-1_loc

Do not wire the remote ON/OFF wall

switch for this gas appliance into a 120V

power supply.

1. Thread the wiring through the holes on the end

panels of the appliance. Take care not to cut the

wire or insulation on metal edges. Route the wire to

a conveniently located receptacle box.

2. Attach the wire to the ON/OFF switch and install

the switch into the receptacle box.

3. Connect the other ends of the wire to the gas

control valve, as shown in Fig. 7.

Fig. 6 EB-1 attachment

Electrical

Inlet Hole

Gas

Inlet Hole

EB-1 Electrical Box

Depending on the specific model,

this box may be installed on either

side of the appliance.

The gas control is equipped with a captured-screw type

pressure test point, therefore it is not necessary to

provide a

/8" test point upstream of the control.

When using copper or flex connector, use only

approved fittings. Always provide a union when using

black iron pipe so that the gas line can be easily

disconnected for burner or fan servicing. See the gas

specification for pressure details and ratings.

Isolate or disconnect this or any other

gas appliance control from the gas line

when pressure testing.

DO NOT subject the fireplace valve to

test pressures exceeding

psi.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 38 39

Comments to this Manuals

No comments

Vermont Castings 360DVSR Operations Instructions Page 10

Comments to this Manuals

Related products and manuals for Fireplaces Vermont Castings 360DVSR