Vermont Castings Stardance SDV30 Operations Instructions download pdf (Page 32)

Stardance Direct Vent/Natural Vent Gas Heater

20007065

Models 3940, 3950 (RF Models) Only

16. Follow procedure for pilot type 2 to replace pilot

oriﬁce.

17. Remove and replace plug on lower right hand side

of the valve; Red for LP and Blue for NG. (Page 26,

Fig. 49)

18. Remove motor top cap. Depress and turn center

plunger until arrow points to correct screw. Red for

LP and Blue for NG. NOTE: Plunger will “snap” into

NG position when arrow is close to blue screw. It will

not “snap” at LP (Red) position. (Fig. 61)

19. Insure manifold pressure remains between 3.2”

- 3.5” w.c. for NG and 9,5” - 10” w.c. for LP. To adjust

the manifold pressure, for NG, using a torque #10

key turn the blue screw clockwise to increase the

manifold pressure. Turn the screw counterclockwise

to decrease the pressure. Use the red screw to

adjust LP.

20. Replace motor top cap.

All Models

21. Replace burner. Slide the burner in at an angle

with left side lower than the right side. Slide the left

side onto the injectors, making sure the burner leg

remains at a 90° angle to the base. Lower the right

hand side down in to place. Make sure the burner is

as far left as possible and the injector shoulders are

inside the burner.

NOTE: It is very critical to keep the left burner leg,

which holds the injectors, at a 90° angle to the base.

(Fig. 62) This keeps the oriﬁces aligned with the

tubes inside burner. Failure to do so could affect the

ﬂame appearance and performance of the unit.

22.Place conversion label on valve.

23.Reinstall the right and left log bracket assembly.

24.Reinstall the rear log bracket.

25.Replace logs.

26.Replace glass and stove front.

Conversion is complete.

FP1037b

comfort valve

convert

3/6/01 djt

LOCAL

REMOTE

•

PILOT

OFF

•

LED

Motor Top Cap

Center

Plunger

Blue - NG

Red - LP

Valve

FP1037b

Fig. 61 Depress and turn center plunger.

ST353a

injector orifice

replace

3/21/00 djt

90°

Left Burner Leg

Injector Oriﬁce

ST353a

Fig. 62 Remove and replace injector oriﬁces.

Table 2. Injector Oriﬁce Size Matrix

Conversion to Natural Gas Input (Btu/h)

Kit # Front Part # Rear Part # Minimum Maximum

000-5021

#54 / .055” 30000514 #44 / .086” 30000334 19,000 28,000

000-5011

Conversion to LP Input (Btu/h)

Kit # Front Part # Rear Part # Minimum Maximum

000-5022

#69 / .029” 30000513 #54 / .055” 30000514 20,000 28,000

000-5012

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Comments to this Manuals

No comments

Vermont Castings Stardance SDV30 Operations Instructions Page 32

Comments to this Manuals

Related products and manuals for Fireplaces Vermont Castings Stardance SDV30