Vermont Castings Stardance SDV30 Operations Instructions download pdf (Page 14)

Stardance Direct Vent/Natural Vent Gas Heater

20007065

Venting System Assemlby - Direct Vent

General Information

The Stardance is approved for installation only with the

vent components listed on Page 12. Follow the vent

component instructions exactly.

For U.S. installations: The venting system must con-

form with local codes and/or the current National Fuel

Gas Code, ANSI Z223.1/NFPA 54.

For Canadian installations: The venting system must

conform to the current CSA B149.1 installation code.

Install the Vent Adapter Pipe

(CFM Corporation Vent Components)

1. Install the Restrictor Plate. Consult the ‘Vent Run

Speciﬁcations’ on Page 8 to determine whether the

restrictor plate is needed. If so, put the restrictor

plate in place within the inner ﬂue collar as shown in

Figure 16.

ST210

install restr

ictor plate

12/4/99 djt

ST210

Fig. 16 Install the restrictor plate only if required for the vent-

ing conﬁguraiotn. Refer to Page 8.

2. Attach Inner Starter Pipe, (found in with the log-

set), to the next section of inner pipe.

• Run a bead of sealant about 1/2” from the upper

end of the Inner starter pipe and join the two sec-

tions together.

• Drill three pilot holes into the Inner Starter and

secure the assembly with three sheet metal screws.

(Fig. 17)

3. Dry ﬁt the Inner Pipe assembly to the stove for

the purpose of determining the center line of the

pipe on the wall.

• Side Wall Terminations: Dry ﬁt the outer elbow

with the vertical outer vent and conﬁrm the centerline

alignment with the wall thimble opening.

4. Attach the Inner Vent Assembly to the stove.

• Run a bead of sealant around the bottom end of

the starter pipe and attach the assembly to the stove

using three 1/4-20 x 3/8” Phillips screws provided in

the parts bag. (Fig. 18)

ST211

attach inner pipe

to next section

12/4/99 djt

CEMENT

First Section of Vent

Pipe

3” Inner

Starter PIpe

#8 x 1/2” Sheet

Metal Screws

ST211

Fig. 17 Connect the inner starter with the next section of in-

ner vent pipe.

ST212

attach inner assy

12/4/99 djt

CEMENT

ST212

Fig. 18 Attach inner assembly to ﬂue collar.

5. Install the Outer Adapter Pipe. Apply a 1/4” bead

of cement around the inside wall of the pipe, about

1” from the end. Insert the pipe over the stove ﬂue

collar, keeping the vertical seam oriented to the back

of the stove. Also, be sure to align holes on the pipe

with the holes on the ﬂue collar of the ﬁrebox. Fasten

the pipe to the holes in the ﬂue collar with the #12 x

1/2” sheet metal screws provided. (Fig. 19)

ST213

install outer adpater



12/6/99 djt

ST213

Fig. 19 Fasten outer pipe with #12 x 1/2” sheet metal screw.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Comments to this Manuals

No comments

Vermont Castings Stardance SDV30 Operations Instructions Page 14

Comments to this Manuals

Related products and manuals for Fireplaces Vermont Castings Stardance SDV30