Vermont Castings RADVT(CS)BSSB Operations Instructions download pdf (Page 38)

3838

Radiance

Direct Vent Gas Heater

20306759

Testing Remote Control System

1. Light the gas appliance following the lighting instruc-

tions on Page 32. Conrm the pilot light is on; it must

be in operation for the remote control to operate the

main gas valve and blower. Appliance control knob

must be in the ON position, and ON/OFF switch must

be in OFF position.

2. Slide the 3 position button on the remote receiver to

the ON position and the main gas ame should ignite.

3. Slide the button to OFF and the main gas ame should

extinguish, but the pilot light will remain lit.

4. Slide the button to RS (the center position). Press the

ON button on transmitter to turn the system ON. The

main gas ame should ignite and blower should come

on after the On delay time is reached and fan speed

you desire is selected.

5. Press the OFF button on transmitter to turn the system

to OFF. The ame should extinguish (the pilot light will

remain lit) and blower should be off after the Off delay

time is you set is reached.

Symptom

1. Battery icon on LCD on transmit-

ter.

2. LCD display is blank.

3. LCD display shows “funny" dis-

play.

4. Appliance does not come on.

5. Receiver cannot receive signal.

6. Blower is not on after the stove is

turned on.

Causes

1. Low battery.

1. Wiring/Electrical connections.

2. Privacy (DIP) switch setting on

transmitter does not match re-

ceiver.

3. Transmitter measure tem-

perature exceeding 99°F and

shows “HI" on LCD.

4. Distance between the trans-

mitter and receiver is more

than 30 feet.

1. Receiver is installed in an en-

closure.

1. Blower setting is off.

2. Blower delay setting is set too

high.

Action

1. Replace batteries. Change the bat-

teries every 6 months.

2. Check battery installation or replace

batteries.

3. Press reset button at the back of the

transmitter.

1. Slide the switch to ON, if appliance

comes on, wiring is not the cause.

2. If appliance, does not come on,

check wiring connections.

1. Make sure the transmitter and re-

ceiver have the same DIP switch

settings.

1. Move transmitter to a cooler place

and wait until temperature drops be-

low 99°.

1. Make sure the operating distance is

less than 30 feet.

1. Make sure the receiver is not locat-

ed inside too tight of an enclosure.

1. Press FAN key to select desired fan

speed.

2. Press and hold Fan key to set de-

sired ON/OFF delays. This is done

in minutes.

Troubleshooting

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 51 52

Comments to this Manuals

No comments

Vermont Castings RADVT(CS)BSSB Operations Instructions Page 38

Comments to this Manuals

Related products and manuals for Fireplaces Vermont Castings RADVT(CS)BSSB