Vermont Castings SA24SKHRN Operations Instructions download pdf (Page 11)

113311857

The pilot will resist lighting on new installa-

tions due to air in the gas supply line. It may

take several minutes to bleed air completely

out of the gas plumbing system through the

pilot line.

This appliance has a pilot which is lit by a spark

ignition device (piezo). If the piezo fails, then light

the pilot using matches following the Match Light-

ing instructions below.

1. STOP!

Read the safety information above.

2. Push in gas control knob slightly and turn clock

wise to “OFF”.

3. NOTE: Knob cannot be turned from “PILOT”

to “OFF” unless knob is pushed in slightly.

Do not force.

4. Wait ﬁve (5) minutes to clear out any gas. If

you then smell gas, STOP! Follow the safety

information above. If you don’t smell gas, go on

to the next step.

5. Turn the control knob counterclockwise

“PILOT” and push in. Continue to hold the con-

trol knob in and push the piezo igniter button in

until the pilot lights.

6. Continue to hold the control knob in for about

one (1) minute after the pilot is lit. Release the

knob and it will pop back up. Pilot should re-

main lit. If it goes out, repeat steps 3 and 4.

7. If the knob does not pop out when released,

stop and call your service technician or gas

supplier. If the pilot will not stay lit after several

tries, turn the gas control knob to “OFF’ and call

your service technician or gas supplier.

8. Turn gas control knob counterclockwise

to “ON”. CAUTION: Be sure ON/OFF/RS switch

is in the off (middle) position. Also, the GWSK

should be in the “OFF” position and/or the

remote should be in the “OFF” position before

turning the control knob “ON”. If pilot goes out,

repeat steps 4 and 5.

9. Turn ON/OFF/RS switch to “ON” or remote po

sition. Turn remote switch to “ON”.

10. Flame is adjustable by rotating the “HI/LO”

knob.

Lighting the Pilot

Before operating, smell all around the appliance area for gas odor. Be sure to smell near the ﬂoor because

some gases (propane) are heavier than air and will “pool” on the ﬂoor.

Use only your hand to push or turn the gas control dial. NEVER USE TOOLS. If the knob will not push in

or turn by hand, don’t try to repair it, call a qualiﬁed technician. Force or attempted repair may result in a

ﬁre or explosion.

What To Do If You Smell Gas

• Do not try to light any appliance

• Do not touch any electrical switch, do not use any phone in your build-

ing

• Immediately call your gas supplier from a neighbor’s phone. Follow the

gas supplier’s instructions

• If you cannot reach your gas supplier, call the ﬁre department

For Your Safety Read Before Lighting

WARNING: If you do not follow these directions exactly, a ﬁre or explosion may result

causing property damage, personal injury, or loss of life.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments

Vermont Castings SA24SKHRN Operations Instructions Page 11

Comments to this Manuals

Related products and manuals for Fireplaces Vermont Castings SA24SKHRN